Subject	Powder Coating PS Reservior
Posted by	backinblack626 on November 13, 2014 at 12:32 PM
	This message has been viewed 527 times.
Message	I know this has been covered so please dont hang me for this question [ http://www.twinturbo.net/nissan/300zx/forums/general/view/2542130/Re-Can-I-Powder-Coat-the-Power-Steering-Reservoir.html ] These are the instructions I based my work off of but I am thinking that the top crimped section will leak without the o ring installed but it can't be powder coated with it in and can't be crimped on afterwards without destroying the finish. My question is how can I powdercoat this reservoir without it leaking or destroying the finish? is the o ring not necessary? Also is there a replacement filter for these that isn't external?
Follow Ups	Powder Coating PS Reservior - backinblack626 12:32:13 11/13/14 I've never had an issue just cleaning it out and coating it. - Woody75 (Denver) 14:00:45 11/13/14 ^^^Ditto (n/m) - ZaXxon 04:37:06 11/14/14 Re: I've never had an issue just cleaning it out and coating it. - backinblack626 09:01:48 11/14/14 I do it normal. - Woody75 (Denver) 09:23:02 11/14/14 what temp do you have to bake it at? (n/m) - aliaZ 09:42:59 11/14/14 I want to say its 350-400 but I dont remember. (n/m) - Woody75 (Denver) 11:29:27 11/14/14 350 is common for light/medium PC (n/m) - -Grimm- 16:45:50 11/14/14 I did wrinkle red, 375 for 15 minutes. (n/m) - ZaXxon 06:29:50 11/16/14
Post a Followup	You cannot reply to this message because you are not logged in.