TwinTurbo.NET: Nissan 300ZX forum - i used Guapo's guide in the faq section. but
Subject
i used Guapo's guide in the faq section. but
Posted by
slayer fan
on February 08, 2020 at 1:23 PM
This message has been viewed
337
times.
In Reply To
Starting rebuilt engine guidance
posted by Kvert
on February 07, 2020 at 07:38 PM
Message
now the pics don't work.
[
http://www.twinturbo.net/nissan/300zx/forums/main/view/1055430/Simple-rig-to-prime-your-oil-pump.html
]
Follow Ups
Starting rebuilt engine guidance
-
Kvert
19:38:03 02/07/20
From what I understand you disconnect the fuel system (n/m)
-
ctheobal
21:02:06 02/07/20
To prime oil
-
BlackholeZ
22:47:03 02/07/20
2nd
-
vorpalZed
09:28:41 02/08/20
And keep a wrench handy to clang on a jackstand. (n/m)
-
MixManMash
15:36:08 02/08/20
*rolls eyes... whistles* (n/m)
-
vorpalZed
22:16:03 02/08/20
lol thats so messed up... i swear I'd grab the nearest
-
nonstopna
18:51:02 02/09/20
If you're really that concerned, check out this prelube tank
-
Polishzx
23:17:45 02/07/20
Also the CAS position should be fine. Check if you have any
-
Polishzx
23:26:48 02/07/20
Yeah those are nice.
-
BlackholeZ
01:28:09 02/08/20
I've fired up many new longblocks..
-
Stanky (BC)
11:02:26 02/08/20
I did the same, no issues.
-
platinumist
13:38:40 02/08/20
This. (n/m)
-
MixManMash
15:33:26 02/08/20
Agreed. I do the same. (n/m)
-
Woody75 (Denver)
12:50:17 02/10/20
i used Guapo's guide in the faq section. but -
slayer fan
13:23:16 02/08/20
Assembly lube on bearing surfaces and cam shaft/lifters
-
ZXRider
20:08:56 02/08/20
Re: Assembly lube on bearing surfaces and cam shaft/lifters
-
nonstopna
19:02:48 02/09/20
I was told any assembly lube on the cylinder walls
-
ZXRider
20:22:40 02/09/20
^Correct
-
-Grimm-
13:12:31 02/10/20
Interesting. Why ATF instead of engine oil?
-
ZXoltan
14:59:44 02/12/20
(From what I was told) ATF acts as a light lubricant for...
-
-Grimm-
13:06:56 02/13/20
I did have a problem building oil pressure
-
Rocket man
18:01:09 02/09/20
This is what I have done for the Z as well
-
-Grimm-
13:15:06 02/10/20
Re: Starting rebuilt engine guidance
-
Kvert
07:02:31 02/17/20
Re: Starting rebuilt engine guidance
-
Kvert
07:47:02 02/17/20
Post a
Followup
You cannot reply to this message because you are not
logged in
.