Subject	you'll lose your power steering if you do that
Posted by	aliaZ on January 20, 2013 at 7:40 PM
	This message has been viewed 254 times.
In Reply To	IIRC you can unplug the hicas control module now and posted by Evan_Wright (Ca) on January 20, 2013 at 07:27 PM
Message	[ http://www.twinturbo.net/nissan/300zx/forums/technical/view/826469/May-have-other-problems.html ]
Follow Ups	Completed my full Hicas delete today - boosTTed 18:49:19 01/20/13 Mine is leaking too. It's on my list of things to do. - NextZ 18:57:35 01/20/13 No, I didn't use any write-ups. I just knew the parts I - boosTTed 19:08:24 01/20/13 IIRC you can unplug the hicas control module now and - Evan_Wright (Ca) 19:27:21 01/20/13 Oh ok. I will look into this. Thanks (n/m) - boosTTed 19:39:35 01/20/13 you'll lose your power steering if you do that - aliaZ 19:40:48 01/20/13 Well I'm going to be pulling my gauge cluster within 2 weeks - boosTTed 20:03:11 01/20/13 Had to run out to the garage to double check and found - Evan_Wright (Ca) 20:07:52 01/20/13 I've also done this without issue. Still have power steering (n/m) - white22sky 20:39:21 01/20/13 the point I was trying to make was that you need to pull - aliaZ 00:05:47 01/21/13 Re: the point I was trying to make was that you need to pull - white22sky 09:18:56 01/21/13 that is odd - aliaZ 09:48:25 01/21/13 That was my understanding of how it worked. - white22sky 11:16:35 01/21/13 if you replaced your power steering rack with a manual one - aliaZ 04:43:58 01/22/13 Sorry if I mis-typed that. But no that would be obvious. - white22sky 08:36:12 01/22/13 True. Thanks. (n/m) - Evan_Wright (Ca) 11:53:33 01/21/13 Correct, unplug the smaller of the two plugs and you're good (n/m) - BigTDogg (MA) 09:53:27 01/21/13 Quick question because it's HICAS related.... - 300ZMang 07:27:39 01/21/13 Re: Awesome! Planning on doing the same in a few months. - BlitZ91TT 08:44:00 01/21/13 Too bad you can't drive it with your misfire now. (n/m) - TriniTT 09:34:52 01/21/13 I found a bad wire/boot that goes from the coil pack to the - boosTTed 14:28:52 01/21/13 could be o2 sensor not fully functioning... just a thought (n/m) - 300ZMang 14:53:12 01/21/13
Post a Followup	You cannot reply to this message because you are not logged in.