Subject	Yes - someone a long time ago posted that the common
Posted by	jzack on July 30, 2006 at 7:36 PM
	This message has been viewed 799 times.
In Reply To	Re: Yes - when I cut the constant 12v going to the injector, posted by Slobo7x on July 30, 2006 at 05:06 PM
Message	connecting point was near the very rear of the plenum (center). When I finally get around to doing this full repair -- I'll weigh the difficulty. If too hard -- I'll just create my own common point and do individual (or daisy chain) runs to each connector. Won't be too hard to make everything nice and neat with some cold wrap electrical tape -- the length of run on the top of the plenum isn't much.
Follow Ups	How-To: Injector Switched Power Line Using Fuse Box Tap - jzack 00:02:31 07/30/06 Re: How-To: Injector Switched Power Line Using Fuse Box Tap - Slobo7x 10:28:41 07/30/06 Yes - when I cut the constant 12v going to the injector, - jzack 10:58:18 07/30/06 Re: Yes - when I cut the constant 12v going to the injector, - Slobo7x 17:06:02 07/30/06 Yes - someone a long time ago posted that the common - jzack 19:36:26 07/30/06 why not just repin it at the ecu connector? (n/m) - aliaZ 23:27:36 07/30/06 details? (n/m) - zgene4 00:12:13 07/31/06 Because the ECU connector is downstream from the injectors - 300zx90 (CO) 09:30:45 07/31/06 ok...thanks (n/m) - aliaZ 16:04:08 07/31/06 Where exactly did you splice your switched 12v into the - Audioquest 15:17:49 08/01/06 2nd - TheSlimOne 11:40:09 08/28/06 Alternate power source for cleaner install - Jehannum 09:04:07 08/28/06
Post a Followup	You cannot reply to this message because you are not logged in.