TwinTurbo.NET: Nissan 300ZX forum - having done it that way on my 300 Degree Camber Kit -
Subject
having done it that way on my 300 Degree Camber Kit -
Posted by
robo (sebring1970)
on December 07, 2005 at 2:13 PM
This message has been viewed
324
times.
In Reply To
But wouldn't the BMC still be in the way for installing the
posted by Zirvana
on December 07, 2005 at 10:16 AM
Message
cut the upper, upper bracket NOT in the wheel well but in the engine bay that holds the upper, upper control arm bolts together - I would have to say "no."
Follow Ups
300Degree Camber Kit Install
-
PakiHomBoy
20:59:14 12/05/05
Thanks a million. Great write up.
-
Nice_Z
22:00:01 12/05/05
Re: Great write up on the install
-
Z pearl
08:13:15 12/06/05
I love that camber tool.....
-
canyoncarver
08:35:48 12/06/05
Re: I love that camber tool.....
-
Z pearl
09:45:58 12/06/05
no problem =) (n/m)
-
PakiHomBoy
10:43:11 12/06/05
I also have this kit but instructions seemed difficult 2 do
-
graffiti
22:50:46 12/05/05
2nd on the SmartTool. I got a Craftsman branded one for $90.
-
just4kinks
00:11:51 12/06/05
one more thing to make it clear
-
PakiHomBoy
00:18:07 12/06/05
did you do the rear? (n/m)
-
E=mz²
09:55:55 12/06/05
no we didnt (n/m)
-
PakiHomBoy
10:34:18 12/06/05
Good Job! Thanks. FAQ. (n/m)
-
Zirvana
12:46:46 12/06/05
VTF (n/m)
-
mousersix (San Antonio)
18:36:06 12/06/05
some folks find it easier to cut the OEM bracket in two
-
robo (sebring1970)
20:13:40 12/06/05
But wouldn't the BMC still be in the way for installing the
-
Zirvana
10:16:59 12/07/05
the bracket is in the wheel well...
-
PakiHomBoy
11:23:23 12/07/05
having done it that way on my 300 Degree Camber Kit - -
robo (sebring1970)
14:13:12 12/07/05
i think we are talking about different things
-
PakiHomBoy
20:14:49 12/07/05
on my car the OEM upper bolts on the drivers side, inside
-
robo (sebring1970)
02:43:31 12/08/05
The new 300 degree camber kit must not use a plate on
-
Zirvana
08:40:56 12/08/05
correct. OEM uses a fixed, thin plate or bracket to hold
-
robo (sebring1970)
18:18:17 12/08/05
Thanks! Understandable. I too would question the removal
-
Zirvana
09:27:13 12/09/05
Post a
Followup
You cannot reply to this message because you are not
logged in
.