TwinTurbo.NET: Nissan 300ZX forum - no problem =) (n/m)
Subject
no problem =) (n/m)
Posted by
PakiHomBoy
on December 06, 2005 at 10:43 AM
This message has been viewed
318
times.
In Reply To
Re: I love that camber tool.....
posted by Z pearl
on December 06, 2005 at 09:45 AM
Message
Follow Ups
300Degree Camber Kit Install
-
PakiHomBoy
20:59:14 12/05/05
Thanks a million. Great write up.
-
Nice_Z
22:00:01 12/05/05
Re: Great write up on the install
-
Z pearl
08:13:15 12/06/05
I love that camber tool.....
-
canyoncarver
08:35:48 12/06/05
Re: I love that camber tool.....
-
Z pearl
09:45:58 12/06/05
no problem =) (n/m) -
PakiHomBoy
10:43:11 12/06/05
I also have this kit but instructions seemed difficult 2 do
-
graffiti
22:50:46 12/05/05
2nd on the SmartTool. I got a Craftsman branded one for $90.
-
just4kinks
00:11:51 12/06/05
one more thing to make it clear
-
PakiHomBoy
00:18:07 12/06/05
did you do the rear? (n/m)
-
E=mz²
09:55:55 12/06/05
no we didnt (n/m)
-
PakiHomBoy
10:34:18 12/06/05
Good Job! Thanks. FAQ. (n/m)
-
Zirvana
12:46:46 12/06/05
VTF (n/m)
-
mousersix (San Antonio)
18:36:06 12/06/05
some folks find it easier to cut the OEM bracket in two
-
robo (sebring1970)
20:13:40 12/06/05
But wouldn't the BMC still be in the way for installing the
-
Zirvana
10:16:59 12/07/05
the bracket is in the wheel well...
-
PakiHomBoy
11:23:23 12/07/05
having done it that way on my 300 Degree Camber Kit -
-
robo (sebring1970)
14:13:12 12/07/05
i think we are talking about different things
-
PakiHomBoy
20:14:49 12/07/05
on my car the OEM upper bolts on the drivers side, inside
-
robo (sebring1970)
02:43:31 12/08/05
The new 300 degree camber kit must not use a plate on
-
Zirvana
08:40:56 12/08/05
correct. OEM uses a fixed, thin plate or bracket to hold
-
robo (sebring1970)
18:18:17 12/08/05
Thanks! Understandable. I too would question the removal
-
Zirvana
09:27:13 12/09/05
Post a
Followup
You cannot reply to this message because you are not
logged in
.