Subject	Re: I love that camber tool.....
Posted by	Z pearl on December 06, 2005 at 9:45 AM
	This message has been viewed 358 times.
In Reply To	I love that camber tool..... posted by canyoncarver on December 06, 2005 at 08:35 AM
Message	:I was debating how I was gonna make mine. Now I know, except I happen to have some 1-1/4 x 3 steel tube laying around that I'll use. If you end up re-shimming, please post the final thicknesses. :-) The only draw-back to using steel is the weight of the tool, the weight of it might have a hard time of fastening itself to the rim of the wheel, thats why I went with aluminum. Plus the devise is all bolted, I was afraid that welding the aluminum would cause to much warping, and the bolts will allow for adjusting the squareness in the future. If you like, PM me and we could exchange ideas or I could send you the drawings. Sorry Ahmed, didn't mean to high-jack you thread. LATER
Follow Ups	300Degree Camber Kit Install - PakiHomBoy 20:59:14 12/05/05 Thanks a million. Great write up. - Nice_Z 22:00:01 12/05/05 Re: Great write up on the install - Z pearl 08:13:15 12/06/05 I love that camber tool..... - canyoncarver 08:35:48 12/06/05 Re: I love that camber tool..... - Z pearl 09:45:58 12/06/05 no problem =) (n/m) - PakiHomBoy 10:43:11 12/06/05 I also have this kit but instructions seemed difficult 2 do - graffiti 22:50:46 12/05/05 2nd on the SmartTool. I got a Craftsman branded one for $90. - just4kinks 00:11:51 12/06/05 one more thing to make it clear - PakiHomBoy 00:18:07 12/06/05 did you do the rear? (n/m) - E=mz² 09:55:55 12/06/05 no we didnt (n/m) - PakiHomBoy 10:34:18 12/06/05 Good Job! Thanks. FAQ. (n/m) - Zirvana 12:46:46 12/06/05 VTF (n/m) - mousersix (San Antonio) 18:36:06 12/06/05 some folks find it easier to cut the OEM bracket in two - robo (sebring1970) 20:13:40 12/06/05 But wouldn't the BMC still be in the way for installing the - Zirvana 10:16:59 12/07/05 the bracket is in the wheel well... - PakiHomBoy 11:23:23 12/07/05 having done it that way on my 300 Degree Camber Kit - - robo (sebring1970) 14:13:12 12/07/05 i think we are talking about different things - PakiHomBoy 20:14:49 12/07/05 on my car the OEM upper bolts on the drivers side, inside - robo (sebring1970) 02:43:31 12/08/05 The new 300 degree camber kit must not use a plate on - Zirvana 08:40:56 12/08/05 correct. OEM uses a fixed, thin plate or bracket to hold - robo (sebring1970) 18:18:17 12/08/05 Thanks! Understandable. I too would question the removal - Zirvana 09:27:13 12/09/05
Post a Followup	You cannot reply to this message because you are not logged in.