TwinTurbo.NET: Nissan 300ZX forum - Good job...... BUT
People Seeking Info
 
   


     
Subject Good job...... BUT
     
Posted by Milo (Sport Z Magazine) on April 20, 2004 at 10:09 AM
  This message has been viewed 465 times.
     
In Reply To How To Remove Iron Flashing From Coolant Galleys posted by PunkZTT(Phoenix) on April 20, 2004 at 02:32 AM
     
Message while you got it out spend $6 and get an elongated (1-2ft)deburring bit and get all of the water passage... especially the #6. Other wise it's a great idea. Another little trick I used was running an probe type magnet into the passage to pick up all the little metal fragments. That was a really good step when I did the passage.

But otherwisde... good job, sir.


     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.