TwinTurbo.NET: Nissan 300ZX forum - Got my VTFAQ:) (n/m)
Subject
Got my VTFAQ:) (n/m)
Posted by
Zenn
on April 20, 2004 at 3:03 AM
This message has been viewed
304
times.
In Reply To
How To Remove Iron Flashing From Coolant Galleys
posted by PunkZTT(Phoenix)
on April 20, 2004 at 02:32 AM
Message
Follow Ups
How To Remove Iron Flashing From Coolant Galleys
-
PunkZTT(Phoenix)
02:32:54 04/20/04
VTF! (n/m)
-
maxboost83
02:41:59 04/20/04
2nd (n/m)
-
Southern_Z [IL]
03:00:19 04/20/04
Got my VTFAQ:) (n/m) -
Zenn
03:03:04 04/20/04
My block has the flashing removed. Highly recommended! VTF (n/m)
-
bb0ys (MA)
07:58:38 04/20/04
Did you pop the freeze plugs to get all the way back?
-
Woody75 (Denver)
08:53:22 04/20/04
No I didn't think of that, have you done it? (n/m)
-
PunkZTT(Phoenix)
12:24:40 04/20/04
Yes, it's the typical way.
-
Woody75 (Denver)
15:32:09 04/20/04
thanks man, i was wondering what people were talking
-
NA300zx (OH)
08:58:52 04/20/04
VTFAQ!! But is that the only place where there is flash? (n/m)
-
BigTDogg (MA)
09:08:51 04/20/04
Nope. The water passage is by far the worst but there
-
Milo (Sport Z Magazine)
16:23:31 04/20/04
my experience >>>
-
yellowzxtt
10:00:22 04/20/04
Good job...... BUT
-
Milo (Sport Z Magazine)
10:09:36 04/20/04
While what you have done may improve cooling of the engine
-
zxjpmzx
12:43:32 04/20/04
Improved flow does not equate to improved cooling
-
lazersos
18:12:36 04/20/04
hmm..
-
PunkZTT(Phoenix)
19:11:43 04/20/04
Don't get me wrong
-
lazersos
21:56:59 04/20/04
This is why I did not VTF. Nothing really proved here
-
robo (sebring1970)
01:56:24 04/21/04
I think it is helpful...
-
PunkZTT(Phoenix)
16:05:23 04/21/04
just my personal opinion, good post overall. I can relate
-
robo (sebring1970)
03:55:07 04/22/04
I just took offense to your post...
-
PunkZTT(Phoenix)
04:10:13 04/22/04
no offense or rudeness intended. as much as possible,
-
robo (sebring1970)
05:10:49 04/22/04
>>>
-
yellowzxtt
11:34:42 04/21/04
The front is worse than the back...
-
PunkZTT(Phoenix)
16:00:49 04/21/04
Post a
Followup
You cannot reply to this message because you are not
logged in
.