Subject	nah AshZ is the MAN. I dont know of an online writeup but
Posted by	ScubaSteve on February 26, 2004 at 11:37 AM
	This message has been viewed 225 times.
In Reply To	ScubaSteve is the MAN! heck with AshsZ :) posted by Madhatter10-6 on February 26, 2004 at 10:06 AM
Message	I dont think you need one for this. Check out the fuel/emission section of this manual: 300zx service manual - engine and emission control overall diagram - turbo model Find your FPR ("pressure regulator" - dead center in diagram), find your prvr ("P.R.V.R. control solenoid valve" on diagram). See the line that goes from plenum to prvr? Make it go from plenum to FPR instead. I did this while high so if I can do it you can do it. --.scubasteve.--
Follow Ups	Question for the Bracket Removal Crew - MatD 06:30:36 02/26/04 I would be sure to keep those on there as they support - AshsZ (as himself) 07:13:31 02/26/04 Quesitons for AshsZ - Madhatter10-6 08:03:17 02/26/04 I'll try this one! - ScubaSteve 09:48:26 02/26/04 the fuel temp sensor sends signal to ecu, and ecu sends - ScubaSteve 10:00:32 02/26/04 ScubaSteve is the MAN! heck with AshsZ :) - Madhatter10-6 10:06:49 02/26/04 nah AshZ is the MAN. I dont know of an online writeup but - ScubaSteve 11:37:59 02/26/04 PRVR is a system for minimizing vapor-lock of the fuel. - AshsZ (as himself) 23:51:01 02/26/04
Post a Followup	You cannot reply to this message because you are not logged in.