Subject	there needs to be a .008" flywheel step and if your putting
Posted by	trik300zx on September 03, 2003 at 11:22 AM
	This message has been viewed 180 times.
In Reply To	Question about flywheel resurfacing???>>> posted by MikeVar82 on September 03, 2003 at 10:57 AM
Message	in a new clutch you need to resruface the flywheel, even tho there isnt any wear on the flywheel surface the surfaced is glazed and heated most likely and will cause chatter and premature clutch failure if its not surfaced. the step should be .008" + or - .005". and be sure whoever resurfaces it doesnt gind off the alighnment pins or dowls
Follow Ups	Question about flywheel resurfacing???>>> - MikeVar82 10:57:55 09/03/03 It's pretty straightforward - Tom B (IN) 11:06:49 09/03/03 Still a bit confused >>>> - MikeVar82 11:15:13 09/03/03 the INNER part is raised were the clutch disc touches. (n/m) - trik300zx 11:23:16 09/03/03 there needs to be a .008" flywheel step and if your putting - trik300zx 11:22:04 09/03/03 another question: how much does it usually run$?? (n/m) - Jobless=Cheap300zx 12:01:58 09/03/03 I charge $30 at my shop, mainly to cover the cost of the - trik300zx 12:06:08 09/03/03 Thanks guys just had it done it cost me 45 bucks (n/m) - MikeVar82 15:12:27 09/03/03
Post a Followup	You cannot reply to this message because you are not logged in.