Subject	Still a bit confused >>>>
Posted by	MikeVar82 on September 03, 2003 at 11:15 AM
	This message has been viewed 112 times.
In Reply To	It's pretty straightforward posted by Tom B (IN) on September 03, 2003 at 11:06 AM
Message	What you guys are saying makes sense but i went into tech and searched and found a post saying "the outer part of the flywheel is .008 further machined than the inner part, that is the inner section is raised". the way you guys described the outer part would be raised and the inner part lower b/c of resurfacing right?
Follow Ups	Question about flywheel resurfacing???>>> - MikeVar82 10:57:55 09/03/03 It's pretty straightforward - Tom B (IN) 11:06:49 09/03/03 Still a bit confused >>>> - MikeVar82 11:15:13 09/03/03 the INNER part is raised were the clutch disc touches. (n/m) - trik300zx 11:23:16 09/03/03 there needs to be a .008" flywheel step and if your putting - trik300zx 11:22:04 09/03/03 another question: how much does it usually run$?? (n/m) - Jobless=Cheap300zx 12:01:58 09/03/03 I charge $30 at my shop, mainly to cover the cost of the - trik300zx 12:06:08 09/03/03 Thanks guys just had it done it cost me 45 bucks (n/m) - MikeVar82 15:12:27 09/03/03
Post a Followup	You cannot reply to this message because you are not logged in.