Subject	It's pretty straightforward
Posted by	Tom B (IN) on September 03, 2003 at 11:06 AM
	This message has been viewed 104 times.
In Reply To	Question about flywheel resurfacing???>>> posted by MikeVar82 on September 03, 2003 at 10:57 AM
Message	The only area that needs to be touched up is where the clutch disk touches the flywheel. Don't take any more off the surface than is needed to clean up any 'stuff' from the previous clutch disk. Hope this helps! Tom Bell IZCC 2802
Follow Ups	Question about flywheel resurfacing???>>> - MikeVar82 10:57:55 09/03/03 It's pretty straightforward - Tom B (IN) 11:06:49 09/03/03 Still a bit confused >>>> - MikeVar82 11:15:13 09/03/03 the INNER part is raised were the clutch disc touches. (n/m) - trik300zx 11:23:16 09/03/03 there needs to be a .008" flywheel step and if your putting - trik300zx 11:22:04 09/03/03 another question: how much does it usually run$?? (n/m) - Jobless=Cheap300zx 12:01:58 09/03/03 I charge $30 at my shop, mainly to cover the cost of the - trik300zx 12:06:08 09/03/03 Thanks guys just had it done it cost me 45 bucks (n/m) - MikeVar82 15:12:27 09/03/03
Post a Followup	You cannot reply to this message because you are not logged in.