Subject	Ohm test the new injectors just to be sure
Posted by	Polishzx on May 30, 2026 at 5:37 PM
	This message has been viewed 17 times.
In Reply To	Injectors 1 and 2 not firing posted by ctheobal on May 29, 2026 at 07:29 PM
Message	If you used dielectric grease in the connectors, too much can sometimes cause the injector connector not to seat. Love to hear about progress being made after a 10-year break! I'm sure Seb will have some ideas too.
Follow Ups	Injectors 1 and 2 not firing - ctheobal 19:29:26 05/29/26 Ohm test the new injectors just to be sure - Polishzx 17:37:15 05/30/26 Thanks! Did use dielectric grease. Did not seem like I used - ctheobal 20:59:17 05/30/26 Yes there is - Polishzx 22:45:13 05/30/26 Thanks Eric (n/m) - ctheobal 22:57:51 05/30/26 Injectors 1&2 show 11.2 ohms same as injector 3. (n/m) - ctheobal 12:17:57 05/31/26 So they're good... The issue isn't the injectors. - Polishzx 15:03:43 05/31/26 Yep. Driving me crazy. Going to try reseating the ECU - ctheobal 20:49:01 05/31/26 Double check your Efi harness is seated in the ECU - itsa300zx 11:39:49 05/31/26 Will do, thank you (n/m) - ctheobal 12:19:10 05/31/26 Re: Injectors 1 and 2 not firing - Zxpress 08:04:17 06/01/26 Thanks John I will try that (n/m) - ctheobal 15:30:24 06/01/26
Post a Followup	You cannot reply to this message because you are not logged in.