Subject	Replaced PTU but Idle issue still present.
Posted by	90Z_NA_Auto on November 11, 2022 at 4:24 PM
	This message has been viewed 236 times.
Message	The new PTU came in a few weeks ago, but I didn't have time to put it in. Went to drive the car today and cylinder 5 was not firing. Verified with Conzult (Saw plenty of light green corrosion on the original connector.) Replaced PTU with the revised one and related wiring harness. The car felt peppier and sounded stronger, but the idle issue is still present. MAF tested good. Previous post on this: [ http://www.twinturbo.net/nissan/300zx/forums/technical/view/1166952/Idle-Troubleshooting.html ]
Follow Ups	Replaced PTU but Idle issue still present. - 90Z_NA_Auto 16:24:27 11/11/22 Ohm test your fuel injectors. (n/m) - Bernie (NoVA) 22:44:57 11/11/22 Re: Ohm test your fuel injectors. - 90Z_NA_Auto 07:15:35 11/12/22 16600-15v02 isn't an upgrade, its old style injectors (n/m) - Bernie (NoVA) 00:10:12 11/14/22 Re: 16600-15v02 isn't an upgrade, its old style injectors - 90Z_NA_Auto 12:50:05 11/14/22 Does not matter, it's still old style injectors. - Bernie (NoVA) 20:44:00 11/14/22 Re: Does not matter, it's still old style injectors. - 90Z_NA_Auto 11:11:01 11/15/22 I would recommend this: - Bernie (NoVA) 01:53:15 11/17/22 Re: Does not matter, it's still old style injectors. - 90Z_NA_Auto 11:17:58 11/15/22 Re: Does not matter, it's still old style injectors. - 90Z_NA_Auto 11:45:49 11/15/22 Re: Does not matter, it's still old style injectors. - 90Z_NA_Auto 13:02:36 11/15/22 Re: Does not matter, it's still old style injectors. - 90Z_NA_Auto 09:21:51 11/16/22 ... - Bernie (NoVA) 20:58:37 11/25/22 You said you saw corrosion on the connector? - Polishzx 19:12:51 11/13/22 Also make sure to use some dielectric grease on the injector - Polishzx 19:35:26 11/13/22 Not really needed on updated old style connectors if - Bernie (NoVA) 00:11:08 11/14/22 I even put a small dab in my new-style injector connectors - Polishzx 13:35:34 11/14/22 Re: You said you saw corrosion on the connector? - 90Z_NA_Auto 12:41:35 11/14/22 Got it, I thought you meant in the injector connector. - Polishzx 13:34:53 11/14/22
Post a Followup	You cannot reply to this message because you are not logged in.