Subject	Assuming you are bridging the main contact circuit, then
Posted by	LitlElvis on January 20, 2022 at 11:49 AM
	This message has been viewed 207 times.
In Reply To	No crank, New starter relay, works only /w bridged wire posted by Z Force1 on January 18, 2022 at 05:45 PM
Message	the energizing circuit has a problem. Use a voltmeter to check if you have 12V to the energizing circuit when the key is turned to the start position. I've seen several poorly installed aftermarket alarm systems cause low voltage to the start relay.
Follow Ups	No crank, New starter relay, works only /w bridged wire - Z Force1 17:45:36 01/18/22 Assuming you are bridging the main contact circuit, then - LitlElvis 11:49:46 01/20/22 Thanks for the reply mate. will check voltage tomorrow - Z Force1 19:06:41 01/20/22 11.9V at the connector, 12.3 at the battery (n/m) - Z Force1 07:47:09 02/02/22 Possibly your clutch switch, or if it's an automatic - LitlElvis 12:57:37 02/02/22
Post a Followup	You cannot reply to this message because you are not logged in.