TwinTurbo.NET: Nissan 300ZX forum - This exact thing happened to me
People Seeking Info
 
   


     
Subject This exact thing happened to me
     
Posted by Mongoose on September 15, 2021 at 9:28 PM
  This message has been viewed 197 times.
     
In Reply To transmission will not go in posted by Unicuma on September 14, 2021 at 11:00 PM
     
Message The alignment tool isn't perfect. If you just let the clutch hang on it, it will end up drooping slightly. I had to hold the clutch up with one hand, continually re-centering it on the alignment tool, while I slowly tightened it to the flywheel. Once you have it mostly tight, remove the alignment tool and take a good hard look at how well it's aligned with the flywheel. Re-seat the alignment tool a number of times. If it isn't perfectly smooth going in, then your tranny won't go in either.

Took me 2 days.

Jason

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.