Subject	Thread size is M10x1.5mm, depending on your stand...
Posted by	itsa300zx on December 01, 2020 at 2:39 PM
	This message has been viewed 203 times.
In Reply To	Bell housing bolt size for engine stand posted by Tdadz32tt on December 01, 2020 at 01:42 PM
Message	get at least 100mm lengths. I got 150mm and a bunch of 1/2" nuts as spacers to fit a variety of stands/mounts.
Follow Ups	Bell housing bolt size for engine stand - Tdadz32tt 13:42:21 12/01/20 Thread size is M10x1.5mm, depending on your stand... - itsa300zx 14:39:01 12/01/20 Just checked, 75mm is enough for my stand. (n/m) - itsa300zx 19:25:02 12/01/20 Re: Bell housing bolt size for engine stand - Rob260 04:59:38 12/02/20
Post a Followup	You cannot reply to this message because you are not logged in.