Subject	Re: Machine shop went crazy! need help
Posted by	DanielThomas on November 04, 2020 at 12:11 AM
	This message has been viewed 246 times.
In Reply To	Machine shop went crazy! need help posted by DanielThomas on November 03, 2020 at 04:10 AM
Message	big shout out to nick letsom at CZP helped me remedy my issue by working out the CR needed and ordering me an oversized gaskets..panic over!
Follow Ups	Machine shop went crazy! need help - DanielThomas 04:10:09 11/03/20 Re: Machine shop went crazy! need help - DanielThomas 00:11:53 11/04/20 I've talked to him a couple of times. Amid some of the - Woodnutz (PA) 05:01:14 11/04/20 Ok... gonna share the feedback? - Zbullet 21:20:28 11/11/20 Did you degree the cams in installation? - Doug71zt(CAN) 15:49:43 11/12/20
Post a Followup	You cannot reply to this message because you are not logged in.