Subject	Re: Possibly dumb question, but alternator belt won't come loose
Posted by	itsa300zx on October 14, 2020 at 9:28 PM
	This message has been viewed 226 times.
In Reply To	Possibly dumb question, but alternator belt won't come loose posted by Zashi on October 08, 2020 at 10:31 PM
Message	Did you loosen the nut that slides along the guided bracket? The long adjusting bolt goes through it. See page ma12 of the FSM. [ http://www.300zx-twinturbo.com/cgi-bin/manual.cgi?list=ma&slide=12 ]
Follow Ups	Possibly dumb question, but alternator belt won't come loose - Zashi 22:31:26 10/08/20 Loosen the bolt on the too mounting tabs on the alt. (n/m) - kickerzx 05:09:06 10/09/20 ...TOP tabs... (n/m) - kickerzx 11:13:14 10/09/20 pump pivot bolt is accessed through front of PS pulley (n/m) - LitlElvis 12:25:58 10/09/20 Right, so I loosened the pump pivot bolt, all the way until - Zashi 15:03:18 10/09/20 There is no nut on the back of the pivot bolt to fall out - LitlElvis 11:13:16 10/11/20 Looks like he’s asking about the alternator, not ps. - itsa300zx 11:51:12 10/12/20 You would be correct, and my reading comprehension is zero (n/m) - LitlElvis 10:59:22 10/14/20 So I've tried everything I could think of - Zashi 18:32:33 10/14/20 Does this help? - LitlElvis 11:32:09 10/17/20 Re: Possibly dumb question, but alternator belt won't come loose - itsa300zx 21:28:17 10/14/20
Post a Followup	You cannot reply to this message because you are not logged in.