Subject	TBH with the mods that you have you should get the 2.5" kit
Posted by	BlackholeZ on May 05, 2020 at 10:14 AM
	This message has been viewed 142 times.
In Reply To	Going back to SMIC from FMIC? Which pipes do I still have? posted by nissubaru on April 30, 2020 at 02:04 PM
Message	Really planar inlets and SMIC piping with SZ 2.5" intercoolers would be the best way to go. It's not the cheap route, but I'm a firm believer in buy once/cry once. -Dan "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne " Purrs like a sexually satisfied black panther." - BigTDogg "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines
Follow Ups	Going back to SMIC from FMIC? Which pipes do I still have? - nissubaru 14:04:36 04/30/20 Re: Going back to SMIC from FMIC? Which pipes do I still have? - itsa300zx 15:10:30 04/30/20 Should still have all factory piping. - Doug71zt(CAN) 18:51:23 04/30/20 TBH with the mods that you have you should get the 2.5" kit - BlackholeZ 10:14:15 05/05/20
Post a Followup	You cannot reply to this message because you are not logged in.