Subject	It's not a huge amount of work. Moving a rear subframe would
Posted by	Ghoztt on January 28, 2020 at 11:15 AM
	This message has been viewed 173 times.
In Reply To	Why would you do all that work to move the engine and trans. posted by itsa300zx on January 28, 2020 at 09:49 AM
Message	be similar. It's almost like the driveshaft is the wrong size? It shouldn't be that tightly pushed in there. 1993 Nissan 300ZX Slicktop 1992 Nissan Skyline GT-R Gunmetal Gray - Long Live the Z and Godzirra! - "Love cars. Love people. Love life." - Mr. K.
Follow Ups	1 piece driveshaft removal - MyBlueZ 17:31:21 01/25/20 Hopefully you've got the driveshaft out by now. If not, here - SirpriZ 13:32:37 01/27/20 Re: Hopefully you've got the driveshaft out by now. If not, here - MyBlueZ 16:18:52 01/27/20 I think that's a good idea. See if you agree with this - SirpriZ 21:19:08 01/27/20 Why would you do all that work to move the engine and trans. - itsa300zx 09:49:36 01/28/20 It's not a huge amount of work. Moving a rear subframe would - Ghoztt 11:15:33 01/28/20 How would unbolting the diff allow for rearward travel of - SirpriZ 13:30:13 01/28/20 I was thinking of dropping the diff nose downwards??? (n/m) - itsa300zx 14:27:09 01/28/20 Re: I think that's a good idea. See if you agree with this - MyBlueZ 13:25:01 01/28/20 You shouldn't need to go that in depth. You did remove - Ghoztt 21:54:43 01/27/20 Re: You shouldn't need to go that in depth. You did remove - MyBlueZ 13:21:11 01/28/20 Good luck and follow up with us. Either get another DS or - SirpriZ 20:01:59 01/28/20 It's out... - MyBlueZ 15:08:56 02/02/20 Well done! (n/m) - SirpriZ 12:39:34 02/03/20 Get a new DS while it's out. That is too much time wasted on - Ghoztt 08:50:02 02/06/20 I'm curious on the length of the Al drive shaft. - itsa300zx 11:39:53 02/06/20 Re: I'm curious on the length of the Al drive shaft. - MyBlueZ 18:42:41 02/06/20
Post a Followup	You cannot reply to this message because you are not logged in.