Subject	Re: Re: Re: idle falls after rev
Posted by	Metacom on May 03, 2019 at 9:11 PM
	This message has been viewed 218 times.
In Reply To	Re: Re: idle falls after rev posted by chinaoreo on May 03, 2019 at 02:21 PM
Message	Have you tried re-setting your idle position? Worked on a Z once that also had a tune with dual intake/seline and would not idle properly with the dual intakes, something was wrong with the preset "plug in" type tune. Can you try running a stock intake setup?
Follow Ups	idle falls after rev - chinaoreo 10:27:46 04/29/19 Did you by any chance calibrate/adjust your throttleblades - kickerzx 13:23:28 04/30/19 Re: Did you by any chance calibrate/adjust your throttleblades - chinaoreo 09:24:10 05/01/19 Re: idle falls after rev - Metacom 14:29:38 04/30/19 Could have droped its learned values if it was all dead (n/m) - kickerzx 14:36:06 04/30/19 Re: Could have droped its learned values if it was all dead - chinaoreo 09:25:52 05/01/19 Re: Could have droped its learned values if it was all dead - chinaoreo 09:35:12 05/01/19 Re: Re: idle falls after rev - chinaoreo 09:24:04 05/02/19 Re: Re: idle falls after rev - chinaoreo 14:21:35 05/03/19 Re: Re: Re: idle falls after rev - Metacom 21:11:35 05/03/19
Post a Followup	You cannot reply to this message because you are not logged in.