TwinTurbo.NET: Nissan 300ZX forum - Upgrading the Rear End/Axles?
People Seeking Info
 
   


     
Subject Upgrading the Rear End/Axles?
     
Posted by imelmo on October 05, 2018 at 9:05 AM
  This message has been viewed 286 times.
     
     
Message So I recently got another Z. It was built by HoustonZ and is about 500ish rwhp on low boost and did 682rwhp on high boost. It also has launch control via Nistune. It is set at about 5500rpm.

I ran it on the street a couple times with no issues (still in low boost). Went to the track Wednesday (again, still in low boost) and the launch was too much for the passenger side half shaft.

So are there any upgraded half shafts available for these? Or are there any stronger rear end/axle combos that can be swapped in?

My previous Z was about 600rwhp and had no issues, but that was with an auto trans and could only launch about 3200rpm before pushing thru the brakes. Would prefer not to get an auto again though.

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.