TwinTurbo.NET: Nissan 300ZX forum - Mines at 42 with vacuum disconnected then goes down to 32
Subject
Mines at 42 with vacuum disconnected then goes down to 32
Posted by
Boostjuice
on June 24, 2018 at 4:09 PM
This message has been viewed
251
times.
In Reply To
I installed a single walbro 485 pump (n/m)
posted by MeatMan (604Z)
on June 24, 2018 at 01:15 PM
Message
With.
Follow Ups
Question for you guys who have converted to E85
-
MeatMan (604Z)
00:21:46 06/24/18
Re: Question for you guys who have converted to E85
-
rhombicblue
08:35:03 06/24/18
I installed a single walbro 485 pump (n/m)
-
MeatMan (604Z)
13:15:31 06/24/18
Mines at 42 with vacuum disconnected then goes down to 32 -
Boostjuice
16:09:27 06/24/18
You may have too much flow for your FPR to bypass.
-
not4resaleZ
10:12:52 06/25/18
you have to bypass the controlller anyway when
-
Boostjuice
12:44:03 06/25/18
I'm running the Ashspec dual pump controller with a
-
not4resaleZ
15:43:33 06/25/18
I am thinking this is the issue too. I hate aftermarket reg. (n/m)
-
MeatMan (604Z)
12:46:01 06/25/18
Use an adjustable fuel pressure regulator.
-
puchy
10:40:21 06/25/18
I was instructed to Bypass the controller by SZ. (n/m)
-
MeatMan (604Z)
12:44:04 06/25/18
I wonder why, maybe because you don’t have an AFPR?
-
puchy
22:23:59 06/25/18
This is my FP fully warmed up at idle
-
MeatMan (604Z)
22:53:27 06/25/18
Single walbro pump will burn out the controller. Yes or No?
-
MeatMan (604Z)
23:43:12 06/25/18
I think if your controller is still stock and hasn't been
-
not4resaleZ
18:05:02 06/26/18
Post a
Followup
You cannot reply to this message because you are not
logged in
.