Subject	I've seen a sleeve and oversize bearing for that
Posted by	Zjustignoreme on May 27, 2018 at 8:12 PM
	This message has been viewed 246 times.
In Reply To	Re: Input shaft bearing noise 92 300ZXTT posted by ZBOOSTT on May 27, 2018 at 02:32 PM
Message	My understanding is that the chatter is the bearing loose on the shaft and you need to put the sleeve on over the damaged part of the shaft and then the oversize bearing on the sleeve. I think. Surprised you haven't gotten a reply, This site is not as high traffic as it used to be.
Follow Ups	Input shaft bearing noise 92 300ZXTT - ZBOOSTT 15:01:53 05/25/18 There is One inside and One you can see Outside - Cjw3 16:46:57 05/25/18 Re: Input shaft bearing noise 92 300ZXTT - ZBOOSTT 14:32:57 05/27/18 Invest in the tools and become the ManTran King! (n/m) - compirate 15:25:38 05/27/18 I've seen a sleeve and oversize bearing for that - Zjustignoreme 20:12:10 05/27/18 Re: I've seen a sleeve and oversize bearing for that - ZBOOSTT 14:43:16 05/28/18
Post a Followup	You cannot reply to this message because you are not logged in.