Subject	I have followed the test procedure in the manual
Posted by	JMartz on May 15, 2018 at 1:09 PM
	This message has been viewed 357 times.
In Reply To	PTU Test - Resistance posted by MLPS300ZX on May 14, 2018 at 03:15 PM
Message	and can tell you that two units I own, fail the test on some pins but work "normally".
Follow Ups	PTU Test - Resistance - MLPS300ZX 15:15:55 05/14/18 I have followed the test procedure in the manual - JMartz 13:09:53 05/15/18 Re: PTU Test - Resistance - Bad Fish 15:27:47 05/15/18 Anyone have resistance levels avail from a working unit? - MLPS300ZX 16:29:00 05/15/18 The first test? - compirate 17:37:07 05/15/18 The 96 FSM only has continuity values, no resistance numbers (n/m) - compirate 17:40:25 05/15/18 I am curious as to what a working unit reads for resistance - MLPS300ZX 18:09:36 05/15/18 Apparently it varies (n/m) - compirate 21:25:01 05/15/18 Yup. I get that. Still curious to what one reads that works. (n/m) - MLPS300ZX 21:40:59 05/15/18 Anything greater than 0 and less than infinity ;) (n/m) - compirate 21:46:57 05/15/18 Re: PTU Test - Resistance - MLPS300ZX 21:50:12 05/15/18
Post a Followup	You cannot reply to this message because you are not logged in.