TwinTurbo.NET: Nissan 300ZX forum - expected to find broken rubber shifter mount but it was ok
Subject
expected to find broken rubber shifter mount but it was ok
Posted by
Slothboy2
on May 12, 2018 at 8:16 PM
This message has been viewed
259
times.
In Reply To
shifter drops down through and hits drive shaft. whats wrong
posted by Slothboy2
on May 12, 2018 at 08:11 PM
Message
shifter falls into hole up to base causing it to hit the drive shaft when fully assembled. What part do i need??
Follow Ups
shifter drops down through and hits drive shaft. whats wrong
-
Slothboy2
20:11:45 05/12/18
expected to find broken rubber shifter mount but it was ok -
Slothboy2
20:16:22 05/12/18
The fork support bracket has a bolt that pushes up through
-
jzack
15:05:46 05/13/18
The shifter itself moves up and down
-
Slothboy2
22:28:36 05/13/18
can't see your photo, use another host site for images. (n/m)
-
itsa300zx
08:49:00 05/14/18
check this out. Whatever used to be here looks disintegrated
-
Slothboy2
18:45:38 05/14/18
not an OEM shifter, looks like a Z1 short shifter.
-
itsa300zx
19:50:22 05/14/18
Solution: ZSpeed Solid Shifter Kit
-
CarolinaZ_TT
08:21:51 05/14/18
anything your missing from this diagram?
-
compirate
10:37:56 05/14/18
My Z1 short throw shifter did the same thing in about
-
Zblackbeast
12:02:16 05/20/18
Post a
Followup
You cannot reply to this message because you are not
logged in
.