Subject	Re: Re: Lightweight aluminum pulley squealing?
Posted by	cosmonautpetrov on April 28, 2018 at 9:06 PM
	This message has been viewed 287 times.
In Reply To	Re: Lightweight aluminum pulley squealing? posted by Zxpress on April 24, 2018 at 06:39 PM
Message	Thank you, I'll try this when I have time! In the meanwhile, it's not a big deal to drive around as is, right? They're tightening to stock spec right now and only squeal for a few seconds on cold starts. Once the car warms up the squealing goes away for good. Even if I turn the car off and let it sit for an hour or two it still won't squeal once I start it. Only happens when the car has been sitting for a few hours in the cold.
Follow Ups	Lightweight aluminum pulley squealing? - cosmonautpetrov 21:45:17 04/23/18 Which pulley? A very common issue with alty and power - jzack 23:51:11 04/23/18 Re: Which pulley? A very common issue with alty and power - cosmonautpetrov 21:08:26 04/28/18 If you have access to - wh0sjeff 23:55:14 05/02/18 Re: Lightweight aluminum pulley squealing? - Zxpress 18:39:00 04/24/18 Re: Re: Lightweight aluminum pulley squealing? - cosmonautpetrov 21:06:50 04/28/18 Re: Lightweight aluminum pulley squealing? - Rob260 04:15:45 04/25/18 Re: Re: Lightweight aluminum pulley squealing? - cosmonautpetrov 21:05:46 04/28/18 The UR PS pulley is misaligned and always has been! - OverZealous (CT) 19:28:42 05/01/18 I installed my PS pulley backwards and the alignment was OK - -Grimm- 18:17:23 05/02/18 I flipped mine backwards too. Still not ok. - OverZealous (CT) 06:56:06 05/04/18
Post a Followup	You cannot reply to this message because you are not logged in.