TwinTurbo.NET: Nissan 300ZX forum - I guess the real question is why mess with rotor machining
Subject
I guess the real question is why mess with rotor machining
Posted by
jzack
on April 12, 2018 at 1:53 PM
This message has been viewed
245
times.
In Reply To
Re: Steering Wheel shake
posted by Metacom
on April 11, 2018 at 08:02 PM
Message
at all? New rotors aren't that expensive unless some specialty type?
Follow Ups
Steering Wheel shake
-
Johnny C
10:03:00 04/11/18
How were the tires balanced? On or off the car? (n/m)
-
jzack
11:16:54 04/11/18
Re: How were the tires balanced? On or off the car?
-
Johnny C
12:20:51 04/11/18
Tension rods and steering rack bushings
-
CarolinaZ_TT
13:33:33 04/11/18
^^ This mine shook badly under braking. (n/m)
-
ctheobal
14:48:34 04/11/18
Re: Steering Wheel shake
-
Metacom
20:02:45 04/11/18
2nd on this. Cheap dial gauge and stand from Harbor Freight
-
ZXoltan
08:31:22 04/12/18
I guess the real question is why mess with rotor machining -
jzack
13:53:21 04/12/18
When did this shake start (miles ago?) what was done >>
-
ZUL8TR
03:37:35 04/12/18
I had a similar issue with recently newly replaced tie rods
-
SkiFly01
10:52:57 04/12/18
Post a
Followup
You cannot reply to this message because you are not
logged in
.