Subject	Careful with the Manifold Flange Studs..
Posted by	Cjw3 on April 08, 2018 at 9:14 AM
	This message has been viewed 182 times.
In Reply To	Tools for rusted exhaust bolts and studs? posted by nelso419 on April 07, 2018 at 09:23 PM
Message	I was doing Brake Cables on the 92 NA, and ended up snapping off two of three studs on the Passenger side Flange.. NO amount of heat or drilling would get the stud remnant to come out of the Flange.. I had to swap out the Manifold.. Not fun but do-able with the engine and crossmember intact.. The Exhaust on this car was out two yeard previous to replace to a One Piece Driveshaft.. Not sure thy it was being such a problem.. I always neversieze EVERYTHING.. Cj
Follow Ups	Tools for rusted exhaust bolts and studs? - nelso419 21:23:52 04/07/18 There are special sockets that can help but you can try - jzack 23:45:58 04/07/18 Careful with the Manifold Flange Studs.. - Cjw3 09:14:13 04/08/18 torch it, that’s how I got the egr tube off mine (n/m) - Zbruh92 15:33:45 04/08/18 Re: Tools for rusted exhaust bolts and studs? - Metacom 23:49:33 04/08/18 Re: Tools for rusted exhaust bolts and studs? - ouikikazz 15:42:42 04/09/18
Post a Followup	You cannot reply to this message because you are not logged in.