TwinTurbo.NET: Nissan 300ZX forum - Thanks, did the bolt holes line up?
Subject
Thanks, did the bolt holes line up?
Posted by
Zbruh92
on April 07, 2018 at 11:05 AM
This message has been viewed
228
times.
In Reply To
Shouldn't be any issues
posted by pandamanz32
on April 05, 2018 at 02:35 PM
Message
What size gasket would be best? 2.5” or 3” or would either work fine? Thanks again for the input
Follow Ups
Any issues with 3” axleback with full 2.5” exhaust?
-
Zbruh92
18:49:29 03/31/18
Re: Any issues with 3” axleback with full 2.5” exhaust?
-
SammybTT(TN)
21:53:20 03/31/18
Not sure how the 2.5" H/X Pipe is going to mate up with the
-
MixManMash
12:38:13 04/02/18
I can make it work lol or have a shop fab some in 2.5”
-
Zbruh92
22:58:00 04/02/18
How beneficial is the 2.5” inlet?
-
Zbruh92
16:19:05 04/07/18
It's beneficial from a spool up point of view.
-
MixManMash
16:31:40 04/07/18
Re: It's beneficial from a spool up point of view.
-
Zbruh92
17:51:17 04/07/18
My dyno chart shows otherwise if you compare it with a
-
MixManMash
10:14:20 04/08/18
Here's a really good post worth reading.
-
MixManMash
10:24:53 04/08/18
Might help if I actually post the link.
-
MixManMash
10:25:28 04/08/18
wow I stand corrected! Definitely need those in my life (n/m)
-
Zbruh92
13:37:47 04/08/18
It's a revelation driving a Z32 with stock turbos and those
-
MixManMash
17:09:12 04/08/18
Shouldn't be any issues
-
pandamanz32
14:35:28 04/05/18
Thanks, did the bolt holes line up? -
Zbruh92
11:05:11 04/07/18
Labree will make any inlet size you need and their mufflers
-
Zblackbeast
15:42:09 04/08/18
Post a
Followup
You cannot reply to this message because you are not
logged in
.