Subject	Well, yes to most of that. Wiring would still be the same
Posted by	compirate on April 04, 2018 at 6:07 AM
	This message has been viewed 241 times.
In Reply To	No, to most of that. This is a 5-speed conversion. New wire posted by Musashi Sword on April 03, 2018 at 06:36 AM
Message	With the exception that the Green/Blue wire from fuse 19 went to the Inhibitor switch on the automatic transmission then the Green/White from that switch goes to the backup lights. Colors would be different if it was custom wired, but the connections are correct. Pull the connector on the switch and short the pins on the connector, should have lights. If not, some connection is bad somewhere.
Follow Ups	Does polarity matter on the reverse back up light switch? (n/m) - Musashi Sword 05:57:44 04/02/18 Polarity never matters on a single pole switch (n/m) - compirate 06:28:01 04/02/18 That's what I thought, so my problem must lie elsewhere... (n/m) - Musashi Sword 08:57:46 04/02/18 small possible caveat if an LED conversion was done. (n/m) - shiers69 09:44:17 04/03/18 No backup lights? It's a pretty simple system - compirate 20:06:47 04/02/18 No, to most of that. This is a 5-speed conversion. New wire - Musashi Sword 06:36:51 04/03/18 Well, yes to most of that. Wiring would still be the same - compirate 06:07:11 04/04/18 Jesus dude, no, to all of that. It is all custom wiring. No - Musashi Sword 06:34:34 04/04/18 Oh so you custom wired it and it doesn't work.... - compirate 14:44:03 04/04/18 It does now. The new wire that was connected to the stock - Musashi Sword 06:25:44 04/05/18
Post a Followup	You cannot reply to this message because you are not logged in.