TwinTurbo.NET: Nissan 300ZX forum - Re: Perhaps a circuit board connector not fully seated when
People Seeking Info
 
   


     
Subject Re: Perhaps a circuit board connector not fully seated when
     
Posted by Boostjuice on February 08, 2018 at 8:25 PM
  This message has been viewed 263 times.
     
In Reply To Perhaps a circuit board connector not fully seated when posted by jzack on February 08, 2018 at 06:35 PM
     
Message I swapped all bulbs out to leds, the gauge bulbs work but the only accessory light that works is the battery one, I took all the leds out and flipped them since they are polarized and may have needed flipped, still nothing. Took the leds out and put the old bulbs back in and nothing, the old bulbs worked before but was trying to swap everything out while it was out. Ill have to recheck everything tonight.

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.