Message |
I am installing AshSpec 2.5" pipes with TiAL 50mm BOVs which are interfering with the AC/Aux fan, so I have removed the fan (shown below) What I noticed is that there are holes in the frame where the fan's feet sit in with rubber grommets, for mounting purposes. I would like to plug these holes because from what I saw, it doesn't look like there are drain holes underneath (unless I'm blind), so I'm worried about water getting in there over time. I thought about putting in the rubber grommets from the feet, but they have a hole in the center of each. Does anyone have any ideas of how to easily plug these holes, short of a permanent solution? I don't want to hack up the fan to put the feet in, and I'm hoping to do something a bit better than putting tape over the holes...
|
|