Subject	If you choose to leave them as is, I personally
Posted by	Aaronw on November 29, 2017 at 9:57 PM
	This message has been viewed 343 times.
In Reply To	Forget to Have Machine Shop Pull Oil Check Valves posted by Joe@Dewla_DeZign on November 28, 2017 at 08:00 PM
Message	Would buy a can or two of brake cleaner and flush out the passages as best I could, with the cleaner and compressed air. Just be sure to coat everything back up with WD40 or whatever you choose.
Follow Ups	Forget to Have Machine Shop Pull Oil Check Valves - Joe@Dewla_DeZign 20:00:09 11/28/17 Don't have any first hand experience, but there was a tech - Tanley (ATL) 15:09:39 11/29/17 Yeah, I did see that one - Joe@Dewla_DeZign 23:11:58 11/29/17 I was going to say that I would pull apart and clean it, but - Tanley (ATL) 08:50:53 11/30/17 If you choose to leave them as is, I personally - Aaronw 21:57:03 11/29/17
Post a Followup	You cannot reply to this message because you are not logged in.