Subject	Your idea is good and it would work well enough
Posted by	Placuch on November 12, 2017 at 4:35 PM
	This message has been viewed 348 times.
In Reply To	Find diameter of cam bearing 1/2 circle and add posted by JMartz on November 12, 2017 at 04:15 PM
Message	Unfortunately I don't have a tool to measure that big of a distance with such accuracy. Honestly, what would be the appropriate tool to use? The most accurate tool i have is an electronic vernier caliper that is accurate down to 0.001" but it doesn't have enough spread (only goes to 150 mm). Regardless I don't think it is an appropriate tool to use.
Follow Ups	How deep? - Placuch 14:15:12 11/12/17 Find diameter of cam bearing 1/2 circle and add - JMartz 16:15:30 11/12/17 Your idea is good and it would work well enough - Placuch 16:35:20 11/12/17 How about just CC the Chambers? (n/m) - Cjw3 21:48:34 11/12/17 It would tell me if heads were machined... - Placuch 23:46:52 11/12/17 We can calculate the CR from what you have there - Cjw3 07:30:12 11/13/17 Re: We can calculate the CR from what you have there - Placuch 09:54:17 11/13/17 What heads do you have? - Cjw3 10:50:48 11/13/17 Re: What heads do you have? - Placuch 15:15:00 11/13/17
Post a Followup	You cannot reply to this message because you are not logged in.