TwinTurbo.NET: Nissan 300ZX forum - Find diameter of cam bearing 1/2 circle and add
Subject
Find diameter of cam bearing 1/2 circle and add
Posted by
JMartz
on November 12, 2017 at 4:15 PM
This message has been viewed
370
times.
In Reply To
How deep?
posted by Placuch
on November 12, 2017 at 02:15 PM
Message
its radius to the distance from deck to cam bearing 1/2 hole edge. This diameter will be close to the cam at that spot. You will be with .001 or 2.
Follow Ups
How deep?
-
Placuch
14:15:12 11/12/17
Find diameter of cam bearing 1/2 circle and add -
JMartz
16:15:30 11/12/17
Your idea is good and it would work well enough
-
Placuch
16:35:20 11/12/17
How about just CC the Chambers? (n/m)
-
Cjw3
21:48:34 11/12/17
It would tell me if heads were machined...
-
Placuch
23:46:52 11/12/17
We can calculate the CR from what you have there
-
Cjw3
07:30:12 11/13/17
Re: We can calculate the CR from what you have there
-
Placuch
09:54:17 11/13/17
What heads do you have?
-
Cjw3
10:50:48 11/13/17
Re: What heads do you have?
-
Placuch
15:15:00 11/13/17
Post a
Followup
You cannot reply to this message because you are not
logged in
.