TwinTurbo.NET: Nissan 300ZX forum - Why? These are the newer pintleless injectors that don't
Subject
Why? These are the newer pintleless injectors that don't
Posted by
MixManMash
on November 07, 2017 at 4:55 PM
This message has been viewed
269
times.
In Reply To
While you were doing the grinding on #1 you could >>
posted by ZUL8TR
on November 07, 2017 at 02:15 PM
Message
have the same failure rate as the old injectors.
Follow Ups
300 Degree Rail - #1 Injector connector can't clear plenum?
-
ZUL8R
17:47:37 11/05/17
PS - 1990TT, Nismo 740cc injectors... (n/m)
-
ZUL8R
17:56:34 11/05/17
See excerpt below from the 300 degree website.....
-
jzack
18:00:08 11/05/17
This. It isn't very much. Just enough at an angle to get
-
MixManMash
19:01:29 11/05/17
Thanks guys. Pulled the plenum, ground it, back on.
-
ZUL8R
20:40:16 11/05/17
While you were doing the grinding on #1 you could >>
-
ZUL8TR
14:15:35 11/07/17
Why? These are the newer pintleless injectors that don't -
MixManMash
16:55:21 11/07/17
Nothing lasts forever. As said by SammybTT just in case (n/m)
-
ZUL8TR
03:08:12 11/08/17
If a TB water jacket bypass and EGR delete has been
-
MixManMash
07:14:43 11/08/17
and if not! (n/m)
-
ZUL8TR
07:55:27 11/08/17
Thanks for advice, all. I've done EGR delete and TB bypass. (n/m)
-
ZUL8R
10:59:29 11/08/17
X2. That's what I did for the just in case. (n/m)
-
SammybTT(TN)
20:42:46 11/07/17
Post a
Followup
You cannot reply to this message because you are not
logged in
.