TwinTurbo.NET: Nissan 300ZX forum - Re: Gasket matching MSP Manifolds
Subject
Re: Gasket matching MSP Manifolds
Posted by
EngineerLV
on September 10, 2017 at 8:00 PM
This message has been viewed
573
times.
In Reply To
Gasket matching MSP Manifolds
posted by Master_Blaster
on September 09, 2017 at 01:44 PM
Message
Bolt the gaskets to manifolds with nuts and washers so they dont move while grinding gaskets. Then use gaskets to scribe and port exhaust ports.
Follow Ups
Gasket matching MSP Manifolds
-
Master_Blaster
13:44:23 09/09/17
Re: Gasket matching MSP Manifolds -
EngineerLV
20:00:20 09/10/17
I think he's saying the gasket is smaller than the MSP port (n/m)
-
ZXoltan
16:14:06 09/12/17
It is
-
EngineerLV
20:33:00 09/12/17
Post a
Followup
You cannot reply to this message because you are not
logged in
.