TwinTurbo.NET: Nissan 300ZX forum - Boost sensor output
People Seeking Info
 
   


     
Subject Boost sensor output
     
Posted by Jehannum on September 04, 2017 at 9:56 AM
  This message has been viewed 549 times.
     
     
Message In my ongoing conversion over to an AEM S2, I'm starting to eliminate the extraneous sensors and vacuum galleries.

To that end, I have a bunch of spare outputs available, and I want to dump the stock boost sensor and just map an output to emulate it, to plug into the body harness in its place.

Does anyone have a voltage curve for its output? I'm assuming that it works a lot like any other MAP sensor in that it has a vref+, ground, and voltage out.

I can probably do it myself, but if anyone has the data handy, it would be awesome if you could share :)

---------------------------------------
Your powers are useless! I'm wearing my tinfoil underwear!

I will not shop at AMS.
AMS steals designs from hardworking Z32 enthusiasts and screws them out of work in a tough economy. I am boycotting, how about you?

2012 Albuquerque Z-car club President

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.