cycle on the injectors? At a bare minimum, you will need: 1. Flex Fuel Sensor with gauge 2. SZ Map switcher ECU or Haltech 3. Walbro 485 fuel pump. You will have to bypass the fuel pump controller. 4. Custom tuning With the above, fueling setup, you'll likely max out at around 600hp on E85. IMHO, you have some serious restrictions and I would recommend opening it up to maximize power, especially at low RPMs. With these adders, you'd be 650-700hp capable. 1. SZ 3" Downpipes 2. SZ 3" - 2.5" Testpipes 3. Modify the outlets of your Stillen Exhaust. They Y-down to less than 2.5" which is a massive restriction. Or go with an SZ 2.5" or 3" catback. 4. Ashspec planar inlet, Ashspec Massive ICs, Ashspec IC piping. Of course, those adders mean you will need the following if you are looking to maximize power: 1. BDE Fuel Rails and bigger top feed injectors (ID1300X). 2. Second Walbro 485 in tank with a Y and a hobbs switch to turn it on.
|