Subject	TT Mitshimoto radiator in NA
Posted by	kentatwater on June 26, 2017 at 4:32 PM
	This message has been viewed 492 times.
Message	I am putting a Mitshimoto radiator in my NA. I am using the Z1 lower and upper mounting plates and going to use a TT radiator shroud. My issue is that there is a bundle of wiring encased in hard plastic behind and on the left side of the hood latch that is sticking back into the engine bay and is going to touch the radiator. The right side of the bundle/hard plastic case appears it will clear. It is the left side that is sticking out toward the radiator. Can this be relocated forward? It appears from my manual that this may contain the air bag harness if I am reading things right. Has anyone else had this problem?
Follow Ups	TT Mitshimoto radiator in NA - kentatwater 16:32:20 06/26/17 Re: TT Mitshimoto radiator in NA - kentatwater 16:35:35 06/26/17
Post a Followup	You cannot reply to this message because you are not logged in.