TwinTurbo.NET: Nissan 300ZX forum - Instead of using bolts I installed threaded shafts into the
Subject
Instead of using bolts I installed threaded shafts into the
Posted by
jzack
on June 18, 2017 at 5:53 PM
This message has been viewed
412
times.
In Reply To
EGR Bolt Reinstall
posted by maur010
on June 18, 2017 at 01:17 AM
Message
upper plenum bolt holes with blue loctite. Made it easier to slide the EGR tube flanges onto the shafts then installed nuts with lockwashers to get everything tight. Makes the next plenum pull and install a little easier too. M
Follow Ups
EGR Bolt Reinstall
-
maur010
01:17:18 06/18/17
If you're positive you are turning them the right
-
doug8867
09:19:29 06/18/17
Instead of using bolts I installed threaded shafts into the -
jzack
17:53:06 06/18/17
Re: Instead of using bolts I installed threaded shafts into the
-
maur010
18:46:38 06/18/17
It really isn't critical- just look at the bolt and make the
-
jzack
21:02:47 06/18/17
Post a
Followup
You cannot reply to this message because you are not
logged in
.