Subject	It's possible the shop messed it up when they pressed it
Posted by	BlackholeZ on May 01, 2017 at 12:51 PM
	This message has been viewed 423 times.
In Reply To	Front wheel bearing question posted by RonZ300 (Socal) on May 01, 2017 at 12:31 PM
Message	but they're pretty beefy bearings. New bearings do have a good bit of friction which can seem abnormally high when you're just trying to turn it by hand. -Dan VTC Solenoid Caps href="http://goo.gl/GaK9E">and install instructions. "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne " Purrs like a sexually satisfied black panther." - BigTDogg "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines
Follow Ups	Front wheel bearing question - RonZ300 (Socal) 12:31:32 05/01/17 It's possible the shop messed it up when they pressed it - BlackholeZ 12:51:35 05/01/17 a shop messed up my install once. pepboys! - Smokiedabear 13:46:13 05/01/17 I did spin it first. It's much tougher to spin after install (n/m) - RonZ300 (Socal) 13:58:39 05/01/17 The other possibility is that it was damaged - JMartz 14:53:54 05/01/17
Post a Followup	You cannot reply to this message because you are not logged in.