TwinTurbo.NET: Nissan 300ZX forum - Smallish needle nosed locking pliers work great for this!
Subject
Smallish needle nosed locking pliers work great for this!
Posted by
jzack
on April 28, 2017 at 12:13 PM
This message has been viewed
382
times.
In Reply To
Injector Phillips Heads Stripped
posted by maur010
on April 27, 2017 at 11:56 PM
Message
Clamp them down tight and tap with a rubber mallot or similar. Used this method for all the screws on my rail. Be sure to replace the screws with something better too!
Follow Ups
Injector Phillips Heads Stripped
-
maur010
23:56:47 04/27/17
Impact screw driver
-
Smokiedabear
02:57:36 04/28/17
If stuck I Tap with hammer on a drift pin, then I use >>
-
ZUL8TR
04:31:05 04/28/17
You've gotten this far, why not remove the fuel rail
-
itsa300zx
12:08:29 04/28/17
^^This is the way to go! Fuel hoses probably have to be
-
jzack
12:15:58 04/28/17
Re: You've gotten this far, why not remove the fuel rail
-
maur010
06:15:15 05/01/17
Who said anything about switching out rails? (n/m)
-
itsa300zx
09:36:14 05/01/17
Smallish needle nosed locking pliers work great for this! -
jzack
12:13:21 04/28/17
Post a
Followup
You cannot reply to this message because you are not
logged in
.