Subject	You've gotten this far, why not remove the fuel rail
Posted by	itsa300zx on April 28, 2017 at 12:08 PM
	This message has been viewed 397 times.
In Reply To	Injector Phillips Heads Stripped posted by maur010 on April 27, 2017 at 11:56 PM
Message	from the engine and work on a bench. Should change the lower insulators any ways. Agreed with the others, vise grips work nicely.
Follow Ups	Injector Phillips Heads Stripped - maur010 23:56:47 04/27/17 Impact screw driver - Smokiedabear 02:57:36 04/28/17 If stuck I Tap with hammer on a drift pin, then I use >> - ZUL8TR 04:31:05 04/28/17 You've gotten this far, why not remove the fuel rail - itsa300zx 12:08:29 04/28/17 ^^This is the way to go! Fuel hoses probably have to be - jzack 12:15:58 04/28/17 Re: You've gotten this far, why not remove the fuel rail - maur010 06:15:15 05/01/17 Who said anything about switching out rails? (n/m) - itsa300zx 09:36:14 05/01/17 Smallish needle nosed locking pliers work great for this! - jzack 12:13:21 04/28/17
Post a Followup	You cannot reply to this message because you are not logged in.