Subject	Re: Re: Test for power on coils, ptu etc with multimeter
Posted by	Spinall4 on April 06, 2017 at 6:31 PM
	This message has been viewed 580 times.
In Reply To	Re: Test for power on coils, ptu etc with multimeter posted by Spinall4 on April 06, 2017 at 04:34 PM
Message	Doing some further testing on my car, it shows a constant +12 volts at each of the 6 wires that go from the output side of the PTU to each individual ignition coil wires any time the ignition of the car is on, and the car is tuned over with the starter. Wire Colors: Red Red white Red Yellow Black Red Blue Solid Red On the input side of the PTU that connectors from the 6 ignition out wires from the ECU, I saw only .1 volt even when the ignition is on and the car is being tuned over with the starter. These wire colors are: Blue Yellow Blue White Blue Red Blue Pink Solid Blue Blue black
Follow Ups	No start after plenum pull and other work done on car. 94 TT - Spinall4 17:08:32 04/05/17 Re: No start after plenum pull and other work done on car. 94 TT - Spinall4 17:26:30 04/05/17 Grounds on manifold hooked up? - Smokiedabear 20:54:57 04/05/17 Test for power on coils, ptu etc with multimeter - Smokiedabear 21:01:18 04/05/17 Re: Test for power on coils, ptu etc with multimeter - Spinall4 16:34:03 04/06/17 Re: Re: Test for power on coils, ptu etc with multimeter - Spinall4 18:31:32 04/06/17 FSM - Doug71zt(CAN) 18:32:21 04/06/17
Post a Followup	You cannot reply to this message because you are not logged in.