Subject	The studs are just molded in. Heat it and pull then replace. (n/m)
Posted by	white22sky on March 23, 2017 at 9:11 PM
	This message has been viewed 246 times.
In Reply To	How about drilling the stud out and then taping the hole posted by jzack on March 23, 2017 at 07:46 PM
Message
Follow Ups	Has anyone repaired a snapped tail light stud? - Polish 17:39:41 03/23/17 How about drilling the stud out and then taping the hole - jzack 19:46:17 03/23/17 The studs are just molded in. Heat it and pull then replace. (n/m) - white22sky 21:11:28 03/23/17 This seems pretty destructive to the surrounding plastic - Polish 01:03:24 03/24/17 There's this stuff we use at my job called Refrasil. - Zknowphobe 11:40:33 03/24/17 Yes you can cause damage. Use did discretion when heating. - white22sky 09:10:30 03/26/17 Thanks for the offer! - Polish 01:06:35 03/24/17 Is it just 1 bolt that's broken? - Goldchocobo 16:22:25 03/24/17 As mentioned, remove with heat - -Grimm- 17:45:06 03/24/17 Pretty much^^ yep. (n/m) - white22sky 09:11:42 03/26/17
Post a Followup	You cannot reply to this message because you are not logged in.