TwinTurbo.NET: Nissan 300ZX forum - Per the manual the pin to bushing clearance needs to be
Subject
Per the manual the pin to bushing clearance needs to be
Posted by
ZaXxon
on February 13, 2017 at 6:29 AM
This message has been viewed
203
times.
In Reply To
Wiseco wrist pins fitment on stock rods
posted by Kvert
on February 12, 2017 at 02:56 PM
Message
0.0002" - 0.0007"
Follow Ups
Wiseco wrist pins fitment on stock rods
-
Kvert
14:56:50 02/12/17
Per the manual the pin to bushing clearance needs to be -
ZaXxon
06:29:35 02/13/17
Follow up
-
Kvert
15:10:37 02/13/17
Shouldn't your machine shop be doing this for you?
-
ZaXxon
14:29:53 02/14/17
Re: Shouldn't your machine shop be doing this for you?
-
Kvert
17:57:54 02/14/17
Post a
Followup
You cannot reply to this message because you are not
logged in
.